 |
Step 1.
Snip off a small branch as your base and then add small tips to it to make a little hand.
|
 |
 |
Step 2.
Lay the first small bunch on the ring and wrap it tightly with the wire. Make sure you pull it as hard as you can so that it is completely secure. Do not cut the wire.
|
|
 |
Step 3.
Make another bunch and lay it in the same direction on the ring. Continue wrapping the wire tightly around the next bunch.
|
|
 |
Step 4.
Continue with this process, going in the same direction until you have gone completely around the entire ring.
|
|
 |
Step 5.
Leave approximately 8-12 inches of wire at the end and cut.
|
Step 6.
Make a loop with the wire by bending it and then twisting the wire together. This is the hanger.
|
|
 |
Step 7.
Secure the Red ribbon with wire at the top of the wreath (12:00 o' clock) Wrap the wire around the wreath and twist in the back to secure.
|
|
 |
Step 8.
Using the paddle wire, add pine cones on the left, right and bottom of your wreath (9:00 o'clock, 3:00 o'clock and 6:00 o'clock).
|
|
 |
Step 9.
Add red berries near the pine cones.
|
|
 |
Step 10.
Enjoy your beautiful wreath.
|
